Birthday Lettering Soy Melt Mold

Helpful Product Information:

Directions:

Soy Wax:
If using for decoration on a candle then you can use the same soy wax as you have in your container.

Soy Melts:
Use either Golden Wax 5715 or All Seasons A27 Soy Wax. Heat soy wax to the manufacturers recommended temperature and add your fragrance, stir for two minutes and lower the pour temperature to around 50-55 degrees C before pouring to your mould. Let the wax set fully before gently popping your melts from the mould.

Melt & Pour Soap: Pour melted soap at a temperature no hotter than 57ºC into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Care:
Hand wash mold in warm, sudsy water.